This kit comes with everything you need to hook your Force Sensing Resistor into your microcontroller or Phidgets Interface Kit. Connect the FSR to the voltage divider board using the 2-Pin female cable, or with the terminal adaptor. Then feed the voltage divider power and ground through the 3-pin cable, and you'll get an analog voltage reading on the third pin of that cable. Check out this video and the videos below for more info.
The FSR in this kit is perfect for robotic grippers, robot feet, and similar applications.
We searched long and hard to find a flat force sensing resistor that we
liked. When we tried these bad boys out for the first time we knew the search
was over. Paper thin and well made, these FSR's are just plain fun to play
with.
Kit Includes
FSR FEATURE LIST
- Various sizes: .2", .5", 1.5", 24" strip
- Rubber backing
- Peel sticker backing
- Choice of male tabs or female connector (FSR Kits only come with female)
- Can use voltage divider to adjust sensitivity band
0.5" Force Sensing Resistor |
 |
|
|
Sensing area diameter: |
|
0.5" |
Total width: |
|
0.75" |
Length: |
|
2.375" |
Thickness: |
|
.5mm |
Pressure Range: |
|
<1.5 psi to >150 psi |
Force Range: |
|
<1N to >100N |
No-load Resistance: |
|
>1M |
Lifetime: |
|
>10M actuations |
Temp Range: |
|
-30°C to +70° |
 |
|
|
Datasheet: |
|
DATA SHEET |
Integration Guide: |
|
Integration Guide |